Инструкция по эксплуатации VICONTE vc-439 — страница 4

EMPTYING THE WATER TANK

• The water tank should be emptied after each use.

- Unplug the steam iron from the power supply.

- While the steam iron is still warm open the water inlet cover hold the steam iron over a sink and allow the steam iron to drain by tipping the point of the steam iron down.

• Gently shake the steam iron to loosen any water drops that may be trapped The warmth of the steam iron should dry out any remaining water.

NOTE: If you empty the water tank after the steam iron has cooled down set the steam iron in an upright position on its heel rest plug it in and set the temperature control dial to maximum ("MAKC" position) wait when the indicator light is off Unplug the steam iron from power supply.

SETTING THE TEMPERATURE

• Insert the plug in the power supply and stand the steam iron upright on its heel rest.

- Set the variable temperature control dial to the desired temperature:

• Synthetics Silk;
•• Nylon;
••• Wool Cotton Linen.

• The correct temperature will be reached when the indication light has turned off.

SPRAYING

• Ensure that there is enough water in the water tank.

- At any temperature by pressing on the spray button a couple of times the laundry can be damped down.

STEAM IRONING

• As indicated on the variable temperature control dial steam ironing is only possible at middle and higher ironing temperature.

• Ensure that there is enough water in the water tank.

- Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug it in.

- Set the variable temperature control dial to the or "•••" or "MAX" position.

• Wait for a while until the indicator light goes out.

- Slide the variable steam control switch to the required position then the steaming will commence.

- When finished turn the temperature dial in anti-clockwise to minimal position "MIN" and unplug the appliance from the power supply.

CAUTION: Avoid coming in contact with escaping steam.