Инструкция по эксплуатации TP-Link TL-WR842ND V1 — страница 4

English

Note 2 How do I restore my Router’s configuration to its factory default settings? 3 What can I do if I can not access the Internet? 1)

Check to see if all the connectors are connected well including the telephone line (for your modem) Ethernet cables and power adapter 2) Make sure that you are connected to the TP-LINK Router with the computer that was originally connected to your modem then log on to the web-based management page and browse to “Network > MAC Clone” click “Clone MAC Address” and then click “Save” Reboot the Router and try to access the Internet from your computer if the problem persists please go to the next step 3)

Log on to the web-based management page and browse to “Network >
LAN” change the default LAN IP address from 192.168.1.1 to 192.168.x.1 (x can be any number from 2 to 254) to avoid an IP conflict with your Modem click the “Save” button; the Router will then reboot and you may try to access the Internet from your computer Please note that the Router can only be accessed using the new LAN IP address (192.168.x.1)

With the Router powered on press and hold the RESET button on the rear panel for 8 to 10 seconds before releasing it

Once the Router is reset the current configuration settings will be lost and you will need to re-configure the Router

Press it for 8 to 10 seconds