Инструкция по эксплуатации TP-Link TL-WA701ND V2 — страница 2

Englis h

Connect to the Access Point with the Ethernet cable or via wireless The default SSID of the Access Point is TP-LINK XXXXXX The XXXXXX is the last 6 characters of the Access Point’s MAC address

Plug the provided power adapter into the power jack on the back of the Access Point and the other end to a standard electrical wall socket Then press the ON/OFF button to power on the device

Turn on all of your network devices and then check to see if the LEDs on the Access Point display normally as the diagram below describes

Note

If the distance between the outlet and the Access Point is too long to supply the power you can refer to the Power over Ethernet (PoE) solution in Appendix: With PoE Setup on page 14

Solid light

Flashing

Solid light or flashing

Flashing if the Wireless Radio function is enabled

Installation

Note 1 The product model shown in this QIG is “TL-WA801ND”,as an example 2 Information for technical support can be found in the last page