Инструкция по эксплуатации Thomas Super 30S Aquatherm — страница 14

Congratulations on your new purchase!
Enjoy your appliance to the full through correct usage.

Areas of application

• Scrubbing of hard floors with hot water.

- Spray-vacuuming for deep cleaning and stain removal of carpeting hard floors and upholstery i.e as wash-vacuum cleaner.

• Wet vacuuming i.e vacuuming water and other spilt liquids.

• Vacuuming of carpeting hard floors upholstery etc with all the benefits of modern floor vacuuming technology.

Unpacking the appliance Unpack the appliance from the carton remove any packaging and identify the following parts and functions in the diagrams at the beginning of this booklet to gain a better understanding of the instructions given below.

Assembly instructions

The parts required for the chassis are to be found loosely packed in the carton.

Assembling the castor wheels

A Undo the snap-on fasteners (3) and lift off the motor block (2).

Take out the extraction liquid tank (28) and cleaning solution Turn the collecting bin (1) upside down i.e with the opening facing the floor

C To facilitate assembly we recommend lightly greasing the pegs at both ends First insert the pegs (3) in the base of the collecting bin (1) then push them in together with the castors as far as they will go Turn the collecting bin (1) back over onto the castors (4) and check that these have been correctly assembled by moving the collecting bin (1) back and forth in all directions.

Fitting the motor block

D Place the motor block (2) on the collecting bin (1) making sure that the surfaces of both parts correspond Secure the motor block (2) by means of both snap-on fasteners (3).

Connecting the flexible hose

Insert the flexible hose (13) in the suction socket (8)
in such a manner that the markings on both the suction socket and the hose connecting piece correspond and the button clicks into place.

Remove the hose by turning the hose connecting piece and slowly with drawing the hose Then attach the desired accessories.

Suction tube holder

The suction tubes (14) complete with accessories and flexible hose (13) can be hooked into the fixtures at the back of the appliance.

Cable storage

G After use the mains cable (1) can be wound loosely in the hand and hung over the notch in the carrying handle as shown in the illustration.

Changing the filter Always pull out the plug before changing the filter!

NOTE!
Hygienic filter change and emptying of the collector bin Emptying the collector bin and charge of all filter typesused in the vacuum cleaner (e g foam paper filters paper filter bags etc.) can be done hygienically To this end please use the hygienic gloves included in the delivery Replacement gloves are readly available at relevant supply stores

Motor protection filter

After each wet suction and spray extraction process check the motor protection filter (33) for contaminations and clean if required For this open the float valve (38) in the direction of the arrow and take the motor protection filter from the suction opening Replace the cleaned or new filter and then reassemble the float valve to the motor block.

Paper filter bag

Place the filter bag (34) inside the collecting bin (1) making sure that the opening located in the cardboard inlay (35) is placed in line with the suction socket (8). Then press the filter bag (34) evenly around the sides of the collecting bin (1). THOMAS paper filter bags are essential when vacuuming fine dust e.g soot ashes sawdust or cement However they are also recommended for normal use as they not only improve the retention of dust but also make filter changes more hygienic.