Инструкция по эксплуатации Sven Stream — страница 10

USER’S MANUAL

5 THE SYSTEM CONNECTION INSTRuCTION

WARNING! All components should be switched off before connection. 5.1 connection to the sound source While connecting to the sound source use the RCA pin type connecting line Please connect correctly the marked «left» jack to other marked «left» plug of other components. 5.2 loudspeakers connection don't shortcircuit acoustics cable ends.

6 SYSTEM INSTALLATION AND OPERATION

first make sure that all connections are correct and then switch on the speaker system.

- Plug the connector for power.

- Revolve regulator knobs to the minimum; press the power button on the backside of the active loudspeaker.

- Adjust the BASS knob to set bass effect.

- Adjust the TReBLe knob to set high-frequency level.

- Adjust the VoLuMe knob to set general system volume level.

- use the soundcard Line-out port to improve sound quality.

7 TROuBLE CHECKING AND SHOOTING

Problem cause

Solution no power

The power plug is connected improperly

Reconnect properly

The power switch is not turned on

Turn on the power switch no sound

The volume regulator is at minimum position

Turn the volume regulator properly

The signal source is connected improperly

Connect properly no woofer sound or volume low

The signal source improper connection

Connect the signal source properly

The woofer volume regulator is at minimum position

Adjust the woofer regulator properly distortion

Volume is too loud

Adjust the volume regulator properly