Инструкция по эксплуатации Star Micronics Serial Interface Unit IS-NP192 — страница 9

English

Baud Rate

DOS Setting

1200

1200

2400

2400

4800

4800

9600

9600

19200

19200

9600

9600

Switches 4 5 6: Not used

Software Settings

This section describes how to set up the software of your computer for printing over a serial interface connection Setups are described for MS-DOS.

Setting up a serial connection on an MS-DOS computer

Remember that the settings you make on your computer must match those you have made using the printer’s Electronic DIP switches.

• Modify your AUTOEXEC.BAT file so that it includes the following line:

MODE LPT1:=COMn This line tells the computer to send printer output to the COMn serial port The letter n stands for the number 1 2 etc You should input COM1 COM2 etc to identify the serial port to which the serial cable from the serial interface unit is connected.

• Also add the following line to your AUTOEXEC.BAT file:

MODE COMn:baud parity data length stopbits p This line sets up the COMn port according to the parameters you input for baud parity data length and stopbits

To set up COM2 for 9600 bps no parity data length of 8 bits and 1 stop bit you should input the following:
MODE COM2:9600,N,8,1,p The letter “p” at the end of the line tells the computer that the printer will continually try to re-send data whenever an error occurs If you need further information about the

MODE

command see your MS-DOS User’s Guide.