Инструкция по эксплуатации SoundMax SM-2402 — страница 6

• Press the STOP/EJECT button to stop the playing press the button again to open the cassette door and you can take out the tape

• Press the "STOP" button followed by the REWIND or FORWARD button to rewind or forward the tape at high speed

Cassette tape recording

• Open the cassette door by pressing the "STOP/EJECT" cassette button

• Insert a blank cassette with the tape-side up into the proper Guide-rails on the inside of the cassette door

• Gently push the cassette door forward (inwards) to close it

• Make sure the tape is fully and properly inserted before doing so

• The set is now ready to start recording which can be done from either the radio or CD-player

Recording from radio

• Set the FUNCTION switch to RADIO position

• Tune to the desired station

• Press the PLAY button and RECORD button on deck simultaneously to start recording

• Press STOP EJECT button to end recording

Recording from CD

• Set FUNCTION switch to CD/MP3 position

• Press RECORD and PLAY buttons on cassette deck simultaneously to start recording

• Press the PAUSE button on deck

• Start the CD-player and select the exact song to be recorded

• Release the PAUSE button on deck to start recording

• Press STOP EJECT button to end recording

Erase protection

• To prevent accidental erasing of a cassette simply break off the two plastic tabs located on the cassette tape’s rear side

• When a cassette with removed plastic tabs is inserted the recording button cannot be pressed

• If a cassette is to be erased and re-recorded at a later stage simply cover the holes on the cassette where the tabs were removed with a piece of strong adhesive tape