Инструкция по эксплуатации Sony PSP-1008 — страница 8

Precautions may be displayed Only connect to a personal access point that you are authorised to use or one that is available through a public wireless LAN or hotspot service.

When travelling note any applicable wireless regulations.

If the PSP™ system or UMD

is brought directly from a cold location to a warm one moisture may condense on the lens inside the system or on the UMD

Should this occur the system may not operate properly

In this case remove the UMD

and turn off and unplug the system Do not put the UMD

back in until the moisture evaporates (this may take several hours) If the system still does not operate properly contact the appropriate PSP™ customer service helpline which can be found within every PSP™ format software manual.

• Do not touch the opening on the rear of the disc (recorded surface of the disc) with your fingers.

• Do not allow dust sand foreign objects or other types of dirt to get on the disc.

• If the UMD

becomes dirty gently wipe the exterior and recorded surfaces of the UMD

using a soft cloth Do not use solvents or other chemicals.

• Do not use a UMD

that is cracked or warped or has been repaired

The UMD

may break inside the PSP™ system leading to injury or malfunction.

Follow the guidelines listed below to help avoid deterioration or discoloration of the PSP™ system:

- Do not use solvents or other chemicals to clean the exterior surface.

- Do not allow the system to remain in direct contact with rubber or vinyl products for an extended period of time.

• Do not use a chemically-treated cleaning cloth to wipe off the system.

For best results go to

(Settings)

(System Settings) and then with the "System Information" screen displayed rotate the analog stick in a circular motion This will adjust the analog stick's range of movement.

For safety reasons unplug the AC Power Cord from the electrical outlet and remove the Battery Pack from the system before cleaning.

Cleaning the exterior surface and LCD screen

Wipe gently with a soft cloth.

Cleaning the connectors

If the headphones or remote control connectors become dirty this could cause noise or interruptions in sound Wipe the connectors with a dry soft cloth to keep in clean condition.

Overseas use

Moisture condensation

handling

Use and handling of the system

Before using the analog stick

Cleaning