
IM015
www.scarlett.ru SL-BS34ED42
SETUP OF USER DATA
You should first set your parameters to perform the analysis.
Push the SET button, the first storage location out of nine (USER0) will light up on the display. You can set the
following:
You can set respective values by pushing “up” and “down” buttons. You should confirm each entered value by
pushing the SET button.
ENTERING PERSONAL DATA
Push the SET button. A free storage location will light up on the display – a user name, for example, USER 01.
Confirm the choice by pushing the SET button or select another free user by pushing buttons , for instance,
USER 02. Push SET to change to other settings.
Then a symbol “a man” or “a woman” will light up. Confirm your choice by pushing the SET button or select
your sex by pushing buttons.
Push SET to change to other settings.
Similarly specify age (age) and height (cm) parameters.
To confirm each parameter push the SET button.
After confirming the last parameter (height, cm) The display will show 0.0 KG and user name, for example, USER
2. Begin weighing. Stand still during weighing until the reading settles.
Attention: during measurement there must be no contact between both feet, calves, shanks or thighs. Otherwise,
the measurement cannot be performed properly.
First the display will show your weight, then in some seconds you will see the following information on the display,
which will appear one by one:
The data inform how fit you are at the moment (see the table).
MESSAGES ON THE DISPLAY
ATTENTION: If an error message is displayed, wait until the appliance shuts down. Switch it on again to restart the
operation. If the error message does not disappear remove batteries from the battery compartment for 10 seconds,
after that insert them again and switch on the appliance.
Selection of the user and personal parameters
Analysis of readings after weighing.
- Improper positioning of the scale. Place the scale on a
flat, firm surface.