Инструкция по эксплуатации Saturn ST-FP8051 — страница 3

bidden to start the unit or press the control button by wet hands.

10 The water temperature should not be over 60

℃ when cleaning the unit.

11 Do not run this unit long-time otherwise the inner parts will be damaged.

12 When the motor is running do not insert your finger or other objects into the machine and container.

13 The instructions for food processors and blenders shall warn of potential injury from misuse They shall state that care shall be taken when handing the sharp cutting blades emptying the bowl and during cleaning.

14 Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.

15 If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Do not use the appliance if the rotating sieve is damaged.

Safety protection: the motor is equipped with protective setting which will turn off the unit automatically while overloading and re-operate it after cooling.

Name of parts

Instruction for use of juicer

Cut the fruit or vegetable into pieces and make sure that they can go through the guide hole.

Put the separating trough on the base and turn it tight clockwise.

Put the filter into position on the connector and then put on the transparent cover and lock the cover the inner lock switch will be connected automatically.

Put on the fruit press on the transparent cover and then locate the juice cup (with foam filtering plate inside) under the juice outlet (make sure the cup in correct direction the side with concave surface should be towards the main unit).

Connect the power and turn the control button to “I” then the unit starts to work.

Put the cut fruit or vegetable in the plate and push them into the guide hole with the fruit

vegetable Press and make sure the volume is not more than1/3

of the guide hole and press them slightly.

Please get rid of the residue in the residue cup.

Note: do not put your finger or other things into the guide hole Otherwise it will be dangerous.

Troubleshooting

Trouble

Possible

Cause

Check

Motor does not operate

Safety lock is not connected

Reassemble the cup and connect with the base correctly.

Motor overheat or smell not good

Too much food or working time to long

Reduce the food and run it again after the unit cool down

Maintenance

1.Avoid any bumping of the appliance otherwise it will be deformed or broken.

2.After usage please clean the appliance and wipe the parts with a dry cloth and store it in dry and windy place.

Cleaning and maintenance

1 The appliance is easier to clean if you do so immediately after use.

2 Do not use abrasive cleaning agents scourers acetone alcohol etc to clean the appliance.

3 Clean these parts with the cleaning brush in warm water with some washing-up liquid and rinse them under the tap.

Electric Circuit Diagram

Specification

Power:

350 W

Working voltage

220-230 V