Инструкция по эксплуатации Saturn ST-EK8010 Hosta — страница 3

surface away from hot objects (e.g hotplates) naked flames; do not place under curtains or low wall-cupboards.

11 You should never leave the appliance unattended during use.

12 This appliance is not intended for use by person (including children) with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety

Children should be supervised to ensure that they do not play with the appliance It is not advised to use this appliance by children under 14 13 Use the kettle only with the base unit supplied and do not use the base unit for any other purposes.

14 Never remove the kettle from its base unit while in operation Switch the appliance off first.

15 Take care to close the lid properly before switching on Otherwise the appliance will not switch off automatically and hot water may overflow.

16 The kettle is for heating water only and is not to be used for any other liquids.

BEFORE USING FOR THE FIRST

TIME

1.Remove all packing materials from the kettle.

2.Before connecting of the kettle check that voltage indicated on the rating label corresponds to the mains voltage in your home.

3.Fill the kettle with cool water up to the “MAX” mark and boil it Empty the kettle The appliance is ready for use.

INSTRUCTION FOR USE

FILTER PLACING

1.Open the lid by pressing on the lid release button.

2.Place the filter between the two grooves near the spout at the front of the kettle.

3.Ensure that the filter is pressed down to the bottom of the grooves and fits correctly then close the lid.

NOTE: Never leave the filter loose in the kettle Never remove the filter while the kettle contains hot water

FILLING

1.Remove the kettle from the base unit.

2.You can fill the kettle with water via the spout or by opening the lid by 5

pressing on the lid release button.

3.Not recommend to fill with less than 1liter of water to prevent the kettle running fry while operating.

4.Do not fill with more than 1.5 liters of water (up to “MAX” mark) Avoid overfilling to prevent the water spilling out during the boiling process.

SWITCHING ON

1 After filling your kettle with water place the kettle on the base unit.

2 Connect plug to power supply and pull down the On/Off switch The appliance will begin to operate and the indicator light will come on.

SWITCHING OFF

When the water boils the kettle will switch off automatically and the indicator light will go off.

NOTE: This appliance has a safety system which automatically switches off the heater element if the appliance is inadvertently switched when empty or if it boils dry In this case let the appliance cool down completely before filling with water again.

SWITCHING ON AGAIN

The kettle can be switched on again after cooling down about 15-20seconds while the kettle has been switched off automatically.

CARE AND CLEANING

1.Always remove the plug from the power supply and let the appliance cool down completely.

2.Clean the outside of the kettle and the base unit with a soft damp cloth then wipe with a dry cloth Do not use scouring 3.

Descale at regular intervals Use a descaling agent which can be obtained from specialist shops and follow the instructions given.

FILTER CLEANING 1 Remove the filter out of the kettle.

2 Place under a tap and rub gently any remaining by soft brush (do not included).

3 Replace the filter between the two grooves near the spout at the front of the kettle.

STORAGE

The cord could be winded into the base unit that has a cord storage compartment.