Инструкция по эксплуатации Saturn ST-EK0012 — страница 3

ФорматФормат: Руководство СтраницСтраниц: 20 КатегорияКатегория: Мультимедиа ДобавилДобавил: OLD

Инструкция для Инструкция по эксплуатации Saturn ST-EK0012 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Назад
/ 20
Вперёд
Страница 3
Never yank on the cord as this may damage the cord and eventually cause a risk of electric shock

If the supply cord of this appliance is damaged it must only be replaced by a repair shop appointed the manufacturer because special purpose tools are required

Avoid touching hot kettle surfacesuse the handle and knobs

To avoid possible steam damage turn the spout away from walls or cabinets when operating the kettle

If operated on wood furniture use a protective pad to prevent damage delicate finishes

To avoid scalding always ensure the lid is correctly positioned before operating

Scalding may occur if the lid is removed whilst heating

Remove and replace the lid carefully when hot

Extreme caution must be used when moving the kettle containing hot water

Never lift the kettle by its lid

Always use the body handle

Do not switch your kettle on if it empty

To protect from electrical hazard do not immerse this kettle power base or cord in any liquid.

Use the kettle only with the supplied base unit Do not use the base unit for other purposes.

To protect against fire do not operate in the presence of explosive and/or flammable fumes

A kettle should not be left connected to a wall socket when the room temperature is likely to fall to outdoor winter temperatures control thermostat may reset to boil energize the element

Do not use the kettle for any purpose for any other uses than those specified in this booklet

Position the lid so that steam is directed away from the handle

Do not remove the lid while the water is boiling.

INSTRUCTIONS FOR USE

Before first use fill the kettle with clean water to maximum capacity and boil Discard the water and repeat.

The kettle should always be unplugged when filling or adding water.

Fill the kettle with water to the desired level Do not overfill or there will be a risk of spillage or spitting The water level indicator will assist you to measure correct amount You can fill the kettle via the spout or after opening the lid Do not forget to close the lid after 5

filling otherwise the kettle will not automatically switch off after use

Do not fill with less that 0.5 liter of water

Do not fill with more than 1.8 liter of water (up to “MAX” indication)

An automatic safety cut-out has been fitted for protection against overheating It will operate if the kettle is switched on when containing insufficient water

If the automatic safety cut-out has operated switch the kettle off disconnect form the power outlet and allow the kettle to cool down for 5-

10minutes.Then refill with water and switch on-the kettle will then boil and cut off as in normal operation

The kettle may be switched off at any time by either pushing the switch of the kettle to the “up” position or by switching the power off at the power outlet

To pour water lift the kettle from the power base and pour

CORDLESS KETTLE

Place the power base on a dry flat surface

Place the kettle on the power base

The electrical connections will be made automatically as the kettle slides onto the power base

Plug the cord into an earthed power socket and switch on by depressing the switch of the kettle to the “down” position

When the water has boiled the kettle will switch off automatically After allowing the kettle to cool down for 30 seconds the water can be brought back to the boil by pushing the switch back to the “down” position During the cooling down time do not force the on/off switch into the “down” (“ON”) position as this can damage the operating mechanism.

Do not remove the kettle from the power-base without first switching off.

The kettle may be switched off at any time by either pushing the switch of the kettle to the “up” position or by switching the power off at the power outlet.

To pour water lift the kettle from the power base and pour.

HOW TO CARE FOR YOUR KETTLE

Wipe the exterior of the kettle with a soft damp cloth or sponge Remove stubborn spots with a cloth moistened with mild liquid detergent Do not use abrasive scouring pads or powders

Never immerse the kettle in water or
Нашли ошибку?