Инструкция по эксплуатации Saturn ST-CM7092 — страница 3

locked firmly and properly.

Funnel should not move when engaged properly.

1 With tank cover open locate slot on both sides of the open coffee maker.

2.Locate tabs on funnel and lower funnel into coffee maker with the handle upright.

3.Firmly press the funnel into the coffeemaker while holding handle upright.

4.Lower funnel handle down so that tabs lock under slots.

Operation instruction:

1) Open a tank cover of the coffee maker fill proper amount water into the with a carafe The water level should not exceed the MAX level.

2) Add coffee ground into the filter.

Usually a cup of coffee need a level spoon of coffee ground but you may adjust according to you taste properly.

3) Then place the filer with coffee ground in the funnel (please see following figure) Then place them together in the funnel support make sure it is assembled correctly See the section «THE DETAILS ASSEMBLING

STEPS FOR FUNNEL».

4) Insert the carafe on keeping warm plate.

5) Plug the power cord into the outlet the LCD will display “12:00 “.

6) Press “ON/OFF” button the red lamp of RUN will be illuminated The appliance will begin working.

Note: You can take out carafe pour and serve at any time The appliance will stop dripping automatically But the time cannot exceed 30 seconds.

7) Do not open the tank cover when the coffee maker is operating The flow back of hot water will damage the appliance.

8) You can take out carafe pour and serve when finish brewing (about one minute later after the coffee stops dripping out.)

Note: the coffee you get will less than the water you have inputted in as some water is absorbed by coffee ground As safety is concerned you had better cover the lid of carafe when pouring that is good to keep warm too.

9) Always turn the coffee maker off and unplug the power cord from the electrical outlet when the coffee maker is not in use.

Note: pay attention to pour the coffee out otherwise you may be hurt as the

temperature of coffee just finished is high.

Automatic start function

If you do not want the coffee maker start operation immediately for example now it is 8:10 am you hope that the coffee maker will automatically start at 1:00 pm first follow steps 1 to

5 of above section then you can set the automatic start function as follows:

1).Press “PROG” button the “LCD” will display “CLOCK”.

Set the current time by pressing the

“HOUR” and “MIN”(see Fig.1).

Note: the time cycle is 24 hours.

2).Press “PROG” button again the

“LCD” will display “TIMER” then set the automatic start time by pressing the

“HOUR” and “MIN”(Fig.2).

3).Press “ON/OFF” twice the green lamp of AUTO will be illuminated after about 10 seconds the LCD will display the current clock you may see the automatic start time by pressing PROG.

Note: You may cancel the automatic start function by pressing ON/OFF If you want to change the automatic start time only following the above 1-3 steps again

At 1:00 pm the green lamp of AUTO

will be extinguished and the red lamp of RUN will be illuminated The appliance will start automatically After brewing you can replace the carafe on keeping warm plate Once the coffee maker is energized the coffee can be kept warm if leave the coffee maker unattended for 2 hours the appliance will be cut off power automatically.

CLEANING AND MAINTENANCE:

CAUTION: Be sure to unplug this appliance before cleaning To protect against electrical shock do not immerse cord plug or unit in water or liquid.

1).Clean the funnel filter carafe and carafe lid after each use in hot sudsy water.

2).Wipe the product’s exterior surface and the keeping warm plate with a soft damp cloth Never use abrasive cleaner to clean it.

CLEANING MINERAL DEPOSITS

To keep your coffee maker operating efficiently you should clean away the mineral deposits left by the water regularly according to the water quality in your area and the frequency use the appliance the detail is as follows: fill the carafe with one part of white vinegar and three parts of cold water pour the water and vinegar mixture into the tank do not place into coffee ground brewing the water-vinegar solution per “operation instruction” repeat it until no yellow liquid comes out if necessary then pour out the mixture brewing with tap water until no vinegar odor is left

HINTS FOR GREAT-TASTING COFFEE

1.A clean coffee maker is essential for making great-tasting coffee Regularly clean the coffee maker as specified in the “Cleaning and maintenance” section.

Always use fresh cold water in the coffee maker.

2.Store unused coffee grounds in a cool dry place After opening a package of coffee grounds reseal it tightly and store it in a refrigerator to maintain its freshness.

3.For an optimum coffee taste buy whole coffee beans and finely grind them just before brewing.

4.Do not reuse coffee grounds since this will greatly reduce the coffee’ flavor.

Reheating coffee is not recommended as coffee is at its peak flavor immediately after brewing.

5.Clean the coffee maker when overextraction causes oiliness Small oil droplets on the surface of brewed black coffee are due to the extraction of oil from the coffee grounds.

6.Oiliness may occur more frequently if heavily roasted coffees are used Technical Data:

Power:

1000W

Rated Voltage:

220-230V

Rated Frequency:

50Hz

Rated Current:

4.54А

Coffee maker

Measuring spoon

Instruction manual with warranty book

Package

ENVIRONMENT FRIENDLY

DISPOSAL

You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal center.