Инструкция по эксплуатации Samsung PS50B530S2W — страница 4

English 4

Assembling the Cables

Enclose the cables in the Holder-Wire Cable so that the cables are not visible through the transparent stand.

Using the Stand-Base

Two or more people should carry the PDP Never lay the PDP on the floor

because of possible damage to the screen Always keep the PDP upright.

The PDP can rotate 20 degrees in right and left directions.

How to assemble the Stand-Base (depending on the model)

Using the 4 screws for securing the stand base and the monitor firmly attach the monitor to the stand base

(The exterior of the set may be different than the picture.)

In case of installing your TV on the wall close the cover (1) on the stand-base connection part using two screws for hiding.

Warning Firmly secure the stand to the TV before moving it as the stand may fall and could cause serious injury.

Two or more people should carry the TV

Never lay the TV on the floor because of possible damage to the screen

Always store the TV upright.

-20° ~ 20°

Checking Parts

Owner’s Instructions

Remote Control

AAA Batteries (2ea)

Power Cord

Cloth-Clean

Warranty Card

Safety Guide Manual (Not available in all locations)

Screws (4ea)

Cover-Bottom

Holder-Ring (4ea)

(Refer to page 34)

Ferrite Core for

Power Cord (1ea)

Holder-Wire Cable

The ferrite core is used to shield the cable from interference When connecting a cable open the ferrite core and

clip it around the cable near the plug.

Connecting and Preparing Your TV

BN68-02355EG-Eng.indb 4

2009-06-30 �� 10:31:35