Инструкция PHILIPS SRU5170 — страница 5

Инструкция

Формат

PDF

Размер

14,04 МБ

Страниц

80

Категория

Пульты ДУ

Добавил

IvanLab515

Инструкция для PHILIPS SRU5170 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Notes:

– Batteries are already installed in the remote control.

– If you wish to set up the remote control for operating your TV, you can skip step 3.

– If your device is a Philips device, you can skip step 5.

– You can exit setup mode at any time by keeping SETUP pressed for three seconds.

– Once installed, a device cannot be deleted from the device list. Only the brand name can

be changed (e.g. if you wish to operate a device type of a different brand).

To delete a device you have to clear the entire memory. For this,

see ‘Restoring the original functions of the remote control’ under 4.‘Extra possibilities’.

1 Switch on the device you wish to set up the remote control for. If the device is a

DVD-player/recorder or video recorder, insert a disk or tape and start playback.

2 Pull out the protective strip from the battery

compartment to activate the batteries.

• If the strip does not come out easily, open the battery

compartment to get better access to the strip.

– The remote control will immediately enter setup mode:

- the display shows ‘ ’,‘ ’ and ’TV?’;

- the backlight turns on;

- the keys that can be used are blinking.

– The remote control is now ready to be set up for operating your TV.

3 Use 4 to select the device you wish to set up

the remote control for (see table on previous page).

4 Confirm with OK.

– The display shows ‘ ’ and ’PHILIPS?’.

The keys that can be used are blinking.

5 Use 4 and 3 to select the brand of your device.

• If the brand of your device is not on the list, you can select

any other brand.

6 Confirm with OK.

7 Keep

yy

pressed until the device responds.

– The display shows ‘ ’.

8 Point the remote control at the device.

– The remote control now starts emitting all known ‘off

(standby)’ codes, one by one. Each time a code is sent,

this is shown on the display: ’TEST 01, 02, 03’, etc.

5

English

Instructions for use

Manual_SRU5170_87 24-04-2007 15:50 Pagina 5

Скачать «PHILIPS SRU5170» — 14,04 МБ СкачатьСкачиваний: 0

Нашли ошибку?