Инструкция по эксплуатации Philips dvp632 02 — страница 2

/02b_8239 210 98393

Important notes for users in the U.K.

Mains plug

This apparatus is fitted with an approved 13 Amp plug To change a fuse in this type of plug proceed as follows:

Remove fuse cover and fuse.

Fix new fuse which should be a BS1362 5 Amp A.S.T.A or BSI approved type.

Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets it should be cut off and an appropriate plug fitted in its place If the mains plug contains a fuse this should have a value of 5 Amp If a plug without a fuse is used the fuse at the distribution board should not be greater than 5 Amp.

Note: The severed plug must be disposed to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral (N) brown = live (L).

¶ As these colours may not correspond with the colour markings identifying the terminals in your plug proceed as follows:
– Connect the blue wire to the terminal marked N or coloured black. – Connect the brown wire to the terminal marked L or coloured red. – Do not connect either wire to the earth terminal in the plug marked E (or e) or coloured green (or green and yellow).

Before replacing the plug cover make certain that the cord grip is clamped over the sheath of the lead not simply over the two wires.

Copyright in the U.K.

Recording and playback of material may require consent See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

VAROITUS

Muiden kuin tässä esitettyjen toimintojen säädön tai asetusten muutto saattaa altistaa vaaralliselle säteilylle tai muille vaarallisille toiminnoille.

01-36 DVP630_Fin_02b1

17/03/2004 4:57 PM