Инструкция по эксплуатации Philips 170C7 — страница 24

Regulatory Information recycle your product to increase the amount of reusable materials and to minimize the amount to be disposed of.

Please find out about the local regulations on how to dispose of your old monitor from your local Philips dealer.

(For customers in Canada and U.S.A.)
This product may contain lead and/or mercury Dispose of in accordance to local-state and federal regulations Foradditional information on recycling (ConsumerEducation Initiative)

RETURN TO TOP OF THE PAGE

Information for UK only

WARNING THIS APPLIANCE MUST BE

GROUNDING.

Important:

This apparatus is supplied with an approved moulded 13A plug To change a fuse in this type of plug proceed as follows:

1 Remove fuse cover and fuse.

2 Fit newfuse which should be a

BS 1362 5A,A.

S.T.A or BSI approved type.

3 Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets it should be cut off and an appropriate 3 pin plug fitted in its place.

If the mains plug contains a fuse this should have a value of 5A If a plug without a fuse is used the fuse at the distribution board should not be greater than 5A.

Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.

Howto connect a plug

The wires in the mains lead are coloured in accordance with the following code:

BLUE "NEUTRAL" ("N")

BROW N "LIVE" ("L")

GREEN & YELLOW "GROUND" ("G")

file: D|/DFU/170C7/russian/170c7/SAFETY/REGS/regulat.htm (10 of 11)2006-07-31 1:47:42 AM