Инструкция по эксплуатации Panasonic AW-PH405E — страница 16

15 (E)

Installation

 Pan-tilt head mounting conditions

Pan-tilt head weight

Mounting specifications

Compatible cameras

Camera weight

Camera anti-drop measures

Compatible lenses

Lens weight

Cable weight

Total weight

Approx 10 kg

Stand-alone installation or installation on the celling

Convertible camera series

AW-E50 AW-E650 AW-E655 AW-E750 AW-E860

Approx 1. kg max.

Wire provided used for mounting

AW-LZ16MD55P AW-LZ16MD7P

AW-LZ17MD9AG

Approx 1. kg max.

Approx 0. kg

Approx 1 kg

Multi-purpose camera series

AK-HC1500G

Approx 1.5 kg

HA1 series HA series

HJ17e series HJ1e series

Approx . kg max.

Approx 15 kg

Mounting the pan-tilt head

Recommended screws

No of screws

M6 screws (hexagonal nuts)

4 pcs

Notes

 Refer to the above table for the total weight of the pan-tilt head with the camera lens cables and any other accessories installed Install the equipment on an installation surface which is capable of ensuring a drop safety equivalent to five times the figure for the total weight.

 The maximum weight of the units which can be installed on the pan-tilt head is 15 kg or so (or approximately 5 kg total for the weight of the pan-tilt head and weight of the units installed on the head) When mounting the pan-tilt head on which units have been installed be sure to mount it on an installation surface which is itself capable of ensuring a satisfactory drop safety.

 Installing the pan-tilt head

Before installing the pan-tilt head check that the above mounting conditions are satisfied and observe the following precautions In order to prevent accidents resulting when the product becomes dislodged or falls down be absolutely sure to proceed as instructed Do not install the pan-tilt head on its side since its prescribed operation and performance cannot be ensured.

 After the pan-tilt head has been installed mount the camera on it.  When installing the pan-tilt head use the four mounting holes to secure the pan-tilt head firmly.  Ensure that the surface on which the pan-tilt head will be installed and the anchor bolts used are sufficiently strong.  Use the M6 hexagon head bolts (including one short bolt) for installation.  Use hexagon head bolts which are longer than the thickness (t) of the mounted member 5 mm.  As shown in the figure of next page use flat washers spring washers and hexagon nuts for the hexagon head bolts.  Use a wrench of the appropriate size to tighten up the hexagon head bolts.  Provide a wire which is strong enough to support the combined weight of the entire pan-tilt head system (which consists of the pan-tilt head camera lens and cable).

 Do not use a surface made of plaster board or wood as this kind of installation surface will not be strong enough If mounting on such a surface is unavoidable take sufficient anti-drop measures.

 Install the pan-tilt head in such a way that the equipment and cable attached to it will not make contact with any surrounding objects when the head is swiveled.

 When the unit is no longer going to be used do not leave it in place and be absolutely sure to remove it.