Инструкция NEC NP04Wi — страница 11

Инструкция

PDF

7,90 МБ

176

Презентационное

МилаДок388

Инструкция для NEC NP04Wi на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

ENG-8

ENG-9

Setup Procedure

Setup Flow

1. Connect the USB cable and the holder to the camera unit.

2. Fix the camera unit onto the projector.

* Fixing procedure for U321H is differed from for other models.

3. Mount the cover on the holder.

4. Connect the projector with the computer.

5. Power on the projector and adjust the position and focus for projected im-

age.

6. Connect the USB cable on which terminal has connected with the camera unit

with the computer.

7. Install the driver and the calibration software on the computer and perform the

calibration.

Warning

- Set up this product on the projector before installing the projector on the ceiling or wall. If

this product is set up after installing the projector on the ceiling or wall, the camera unit may

not be ﬁxed properly and it may cause of falling down and resulting in injury. At the same

time, it may cause of damage on the camera unit.

- Make sure to fasten the screws after ﬁxing on the camera unit. If the screws are not fastened

securely, the camera unit may fall down and result in injury. At the same time, it may cause

of damage on the camera unit.

- Do not hold the camera unit for moving the projector and do not apply excessive force to

the camera unit. It may cause of damage on the camera unit and resulting in injury.

Preparation:

- Prepare a plus headed screw driver

- However the holder and the cover has been in engaged condition for shipment, remove the holder

by pressing the button on the cover.

For ﬁxing on U321H, you need to seal the gasket on

the holder. Peel off the release paper on the rear face

of the gasket, attach it to the arrow pointed position on

the illustration.

align corners

Скачать «NEC NP04Wi» — 7,90 МБ СкачатьСкачиваний: 0

Инструкция NEC NP04Wi — страница 11

Другие руководства из этой категории