
IDENTIFICATION OF CONTROLS
1 (STANDBY)
• With the corresponding end of the mains power cord connected
to the AC mains input of the D7050 and the plug connected to a
mains power source, press (Standby) to switch ON the D7050
from standby mode. The Standby indicator will turn from amber to
bright/white color. Pressing (Standby) again turns the unit back
to standby mode.
IMPORTANT NOTE
The D 7050 will automatically go to standby mode if there is no user
interface interaction within 30 minutes.
2 VOLUME
• Adjust audio level by turning clockwise or counterclockwise.
3 S (SOURCE)
• Rotate to select desired Source.
4 DISPLAY
• Illuminate the selected or active Source (COAXIAL1, COAXIAL2,
OPTICAL1, OPTICAL2, COMPUTER, AIRPLAY, DOCK, BT) and current
audio level.
• Display follows the orientation of the unit - vertical and horizontal
view as shown on the front cover.
IMPORTANT NOTE
Display shall temporarily turn o if there is no user interface interaction
within 5 minutes. Restore display by sending a remote control
command or rotating any of the controls.
5 PHONES
• A 3.5 mm stereo jack socket is supplied for headphone listening.
• Specially designed low noise headphone circuitry can accommodate a
wide range of phones, even 600 Ohm studio models.
• Ensure that the volume control is turned to minimum (fully
counterclockwise) before connecting or disconnecting
headphones. Listening at high levels can damage your hearing.
• Inserting a headphone jack into this socket automatically switches
o the loudspeakers.
6 RESET
• Restore factory default settings.
7 WPS/JB
• Use to setup wireless network connection.
8 AUDIO OUT
• These output terminals have dual function. They are used either as
PRE OUT or SUBWOOFER terminals.
• Always turn OFF the D 7050 and associated external devices before
connecting or disconnecting anything to the AUDIO OUT sockets.
PRE OUT
• The AUDIO OUT sockets can be used to drive an additional amplier.
Use a dual RCA cable to connect AUDIO OUT to the corresponding
analog audio input of compatible devices such as ampliers,
receivers or other applicable devices.
• AUDIO OUT will be aected by the D 7050’s volume control settings.
Rotate the VOLUME control to adjust the output level of the AUDIO
OUT sockets.
SUBWOOFER
• Use a dual RCA cable to connect AUDIO OUT to the low level input
of a powered subwoofer.
• Low frequency information up to 200Hz is sent to the connected
subwoofer via AUDIO OUT.
9 +12V TRIGGER IN
• Connect this +12V Trigger input to the remote device’s
corresponding +12V DC output jack using a mono cable with
3.5mm male plug. The controlling device must be equipped with a
+12V trigger output to use this feature.
10 LAN
• LAN connection must be setup for wired connection to be
established. Set up a Wired Ethernet broadband router with
broadband internet connection. Your router or home network
should have a built-in DHCP server to consummate the connection.
• Using a standard straight-through Ethernet cable (not supplied),
connect one end of the Ethernet cable to the LAN port of your wired
Ethernet broadband router and the other end to D 7050’s LAN port.
AUDIO OUT
+12V
TRIGGER
IN
OPTICAL
COMPUTER
DIGITAL AUDIO INPUT
LAN
100-240V 50/60Hz
SPEAKERS
RIGHT
LEFT
WPS/JBRESET
21
1
2
L
R
COAXIAL
6 7 8 9
10 11 12 13 14 15
2
1
3
4
5
5
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERL ANDSSVENSKAРУССКИЙ