Инструкция MICROLIFE BP W100 — страница 9

Инструкция

PDF

1,07 МБ

Для здоровья

IvanTech66

Инструкция для MICROLIFE BP W100 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

7BP W100

2. Replace the batteries – ensure correct polarity as shown by the

symbols in the compartment.

3. To set date and time, follow the procedure described in «Section 2.».



The memory retains all values although date and time (and

possibly also set alarm times) must be reset – the year number

therefore flashes automatically after the batteries are replaced.



Use 2 new, long-life 1.5V, size AAA batteries.



Do not use batteries beyond their date of expiry.



Remove batteries if the instrument is not going to be used for

a prolonged period.

Using rechargeable batteries

You can also operate this instrument using rechargeable batteries.



Only use «NiMH» type reusable batteries.



Batteries must be removed and recharged when the flat

battery symbol appears. They should not remain inside the

instrument as they may become damaged (total discharge as

a result of low use of the instrument, even when switched off).



Always remove the rechargeable batteries if you do not intend

to use the instrument for a week or more.



Batteries cannot be charged in the blood pressure monitor.

Recharge batteries in an external charger and observe the

information regarding charging, care and durability.

8. Error Messages

If an error occurs during the measurement, the measurement is inter-

rupted and an error message, e.g. «ERR 3», is displayed.

Error Description Potential cause and remedy

«ERR 1» Signal too

weak

The pulse signals on the cuff are too weak.

Re-position the cuff and repeat the

measurement.*

«ERR 2» Error signal During the measurement, error signals

were detected by the cuff, caused for

instance by movement or muscle tension.

Repeat the measurement, keeping your

arm still.

«ERR 3»

No pressure

in the cuff

An adequate pressure cannot be gener-

ated in the cuff. A leak may have occurred.

Check that the cuff is correctly connected

and is not too loose. Replace the batteries

if necessary. Repeat the measurement.

«ERR 5» Abnormal

result

The measuring signals are inaccurate and

no result can therefore be displayed. Read

through the checklist for performing reli-

able measurements and then repeat the

measurement.*

Скачать «MICROLIFE BP W100» — 1,07 МБ СкачатьСкачиваний: 0

Инструкция MICROLIFE BP W100 — страница 9

Другие руководства из этой категории