Инструкция MICROLIFE BP 3AS1-2 — страница 10

Инструкция

PDF

0,87 МБ

Для здоровья

LeoДок351

Инструкция для MICROLIFE BP 3AS1-2 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

5.5.Inflating further

If the cuff is not inflated sufficiently, the measurement is broken off

after a few seconds and a flashing arrow pointing upwards appears

in the display. It is then necessary to inflate further to at least

20 mmHg higher than the previous value. The instruction to inflate

further can appear several times if the pressure is still not sufficient.

Attention:

If the cuff is inflated too far (over 300 mmHg), «HI» appears in the

display and a warning signal is sounded. The cuff pressure must

then be immediately released by pressing the «0/I» button.

As soon as the cuff is inflated sufficiently and the measurement is

proceeding, continue as described under points c-d.

5.6.Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for

any reason (e.g. the patient feels unwell), the 0/I button can be

pressed at any time.

The device immediately lowers the cuff-pressure automatically.

5.7.Memory – displaying the last measurement

The measured results are stored in the instrument until

a new measurement is carried out or the batteries are

removed. You can call up the stored values at any time by

pressing the O/I button for at least 3 seconds.

6. Error messages/malfunctions

If an error occurs during a measurement, the measurement

is discontinued and a corresponding error code is displayed.

(Example Error no. 1)

* Please consult your doctor, if this or any other problem occurs repeatedly.

Error No. Possible cause(s)

ERR 1 The systolic pressure was determined but afterwards the cuff pressure fell below 20 mmHg.

This situation can occur, for example, if the tube becomes unplugged after the systolic blood

pressure has been measured. Further possible cause: No pulse has been detected.

ERR 2 Unnatural pressure impulses influence the measurement result. Reason: The arm was

moved during the measurement (Artefact).

ERR 5 The measured results have indicated an unacceptable difference between the systolic and

diastolic pressure. Take another measurement, carefully following the instructions. Contact

your doctor, if you still obtain unusual results.

The pressure in the cuff is too high (over 300 mmHg) OR the pulse is too high (over 200

beats per minute). Relax for 5 minutes and repeat the measurement.*

The pulse is too low (less than 40 beats per minute). Repeat the measurement.*

Скачать «MICROLIFE BP 3AS1-2» — 0,87 МБ СкачатьСкачиваний: 0

Инструкция MICROLIFE BP 3AS1-2 — страница 10

Другие руководства из этой категории