Инструкция KORTING OKB 752 CMX — страница 28

Инструкция

PDF

2,42 МБ

Плиты / Духовки / Печи

ОлегЧитате

Инструкция для KORTING OKB 752 CMX на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

ELECTRICAL CONNECTION

Electric connection has to be done according to rules and law provisions in force.

Before doing the connection, check the following:

- The electric power and sockets are suitable to maximum power of the oven. (See data plate on the

appliance).

- WARNING: THIS APPLIANCE MUST BE EARTHED.

The appliances electrical safety can only be guaranteed when it has been correctly connected to

a properly earthed power supply, as laid down in the regulations for electrical safety.

Important: the manufacturer cannot be held responsible for any damage to persons or objects due

to the lack of an earth connection.

- Never use reducers, adaptors or branches for connections.

CONNECTING OF SUPPLY CABLE

If apparatus is not fitted with feeding cable, use cable Mod. H05RR-F 3 x 1.5 sq. mm. stating suitable

section of the cable which has to be connected to terminal.

To obtain that you have to:

- Connect the supply cable to the terminal strip of the oven (fig. 3), keeping the earth wire 3 cm. longer

than the active conductors (live/neutral) .

- Connect cables wires as follows:

L = (live) brown or red wire

N = (neutral) blue wire

= (earth) yellow - green wire.

N.B. supplys cable temperature should never reach a temperature 50°C above the room

temperature in any point.

Connection to normal socket

Connect feeding cable a normal plug suitable to the load stated on data plate.

When the cooker has been built-in household check that the plug is accesible.

Direct connection to electric supply

If an appliance is not equipped with supply cable and plug,

the power supply must be fitted with a

disconnect switch in which the distance between contacts permits total disconnection in accordance

with overvoltage category III, as required by installation regulations.

The yellow/green earth wire should not be controlled by the switch.

ATTENTION: If the supply cable is damaged, it must be replaced by the manufacturer or by his after-

sales service, or by a similar qualified person, in order to prevent any risk.

fig. 3

Скачать «KORTING OKB 752 CMX» — 2,42 МБ СкачатьСкачиваний: 0

Инструкция KORTING OKB 752 CMX — страница 28

Другие руководства из этой категории