Инструкция GRILLO Climber 910 — страница 17

Инструкция

PDF

2,12 МБ

Садовая техника

IvanPro455

Инструкция для GRILLO Climber 910 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

– Blades fault – Check that the blades are correctly mounted

– Sharpen or change the blades

– Adjust the tension of the plate motor belt

Vibrations during operation

– Blades unbalanced – Balance blades or replace if damaged

– Fastenings are loose – Check and fasten the blade fixing screws and the

fixing screws of the engine and chassis.

Incorrect PTO engagement

– When the PTO button is pressed, the blade – Check the battery voltage, it must be at least

does not engage 12V

– Check the levelness of the blade brake and the

electromagnetic clutch, 0.3 mm.

ELECTRICAL SYSTEM

The electrical system is protected by a fuse which cuts out the entire electrical system if blown.

After finding and repairing the fault, replace the fuse with another of the same rating.

Never replace the fuse with one of a different rating.

The electrical system fuses are underneath the tank (Fig. 19).

If the problems persist after all the procedures described above have been carried out, contact the

Authorised After-Sales Service Centre.

Never attempt to make difficult repairs unless you have the necessary equipment and technical expertise.

IMPORTANT!

– Take care not to reverse the battery polarity.

– Never operate the mower without the battery, since it is equipped with a charge regulator.

– Take care not to cause short-circuits.

THE MACHINE DOES NOT REMAIN IN NEUTRAL

Adjust the zero return device by tightening or loosening it (Fig. 17).

To adjust the forward and reverse travel speeds, use the screws Fig. 18.

ENDING WORK

After mowing, disengage the blades and drive back to base with the cutting plate in the highest position.

To stop, move the travel lever to the STOP position (2, Fig. 1/B), set the throttle lever on the minimum

rpm, switch off the engine by turning the key (1, Fig. 7) and lower the plate to the lowest position, engage

the parking brake (Fig. 21).

CLEANING

Clean the outside of the mower after each use.

STORAGE AND PROLONGED PERIODS OF DISUSE

Store the mower in a dry place, away from atmospheric agents, and preferably cover with a sheet.

If the mower is not going to be used for a long period (over 1 month), disconnect the red battery cable and

follow the instructions given in the engine manual. Also lubricate all of the articulated joints.

Regularly check that the battery voltage does not drop below 12 volts. If it does, recharge the battery.

The travel drive disengager device is on the left-hand rear wheel; if the machine breaks down and has

to be towed, move the lever outwards (Fig. 20).

Скачать «GRILLO Climber 910» — 2,12 МБ СкачатьСкачиваний: 0

Инструкция GRILLO Climber 910 — страница 17

Другие руководства из этой категории