Инструкция по эксплуатации Evenflo Jenny Jump Up Daisy Scribble — страница 4

ФорматФормат: Руководство СтраницСтраниц: 5 КатегорияКатегория: Игрушки ДобавилДобавил: OLD

Инструкция для Инструкция по эксплуатации Evenflo Jenny Jump Up Daisy Scribble на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Назад
/ 5
Вперёд
Страница 4
Перед началом использования

Answers Advice Affirmation.

Visit us at: • USA: 1-800-233-5921 8 AM – 5 PM EST

• Canada: 1-937-773-3971 • México: 01-800-706-12-00

Before You Start

The straps must be installed from front to back on each side of the jumper AND with the toy loops facing toward the child as shown in the illustration DO NOT install straps from left to right or the jumper will not hang properly NOTE: Use only Evenflo toys with this exerciser (not included)

Strap

Front

Toy Loop

Toy Loop

Tube Access Flap (2)

Strap Flap (4)

Strap

Clamp and Spring Housing Assembly

3 Insert the other looped end of strap

into the right rear flap

then pull through the back side as shown NOTE: Make sure the strap is not twisted.

4 Repeat steps 1-3 and insert the other strap through the left front

and left rear flaps

G.

2 Pull the strap

through the slot on the back of flap

as shown.

1 Select one strap

Locate the looped end that is nearest the toy loop

Insert that end into the front slot on the right front strap flap

on the seat

D.

NOTE: Make sure the toy loop

is facing upward as shown.

Assembly

Front

WARNING

Failure to follow each of the following warnings and instructions can result in serious injury or death.

• ADULT SUPERVISION REQUIRED NEVER leave child unattended ALWAYS keep child in view.

- ONLY for use by children who are able to hold their head upright unassisted (approximately 4 months of age) AND weighing no more than 24 lbs (10.8 kg).

DO NOT use if child’s armpits are below top of seat.

• DO NOT use with children who can stand unassisted.

DO NOT use if child is able to stand flat-footed with exerciser adjusted to its highest position.

ONLY for use in indoor interior doorways Wall MUST be at least 3 inches (8 cm) thick but not more than 6 inches (15 cm)
thick Doorway trim MUST be firmly attached with flat part on top at least 1/2 inch (13 mm) wide.

• DO NOT use in doorways with plastic molding or near stairs CHECK INSTALLATION: Before each use:

- BE SURE exerciser is securely fastened to doorway Pull down firmly on strap coming from bottom of doorway clamp If there is any movement in door trim DO NOT use exerciser in that doorway.

• BE SURE straps and seat are securely fastened.

- DISCONTINUE USE if any parts are damaged or missing.

- STRINGS CAN CAUSE STRANGULATION!

DO NOT place items with a string around child’s neck such as hood strings or pacifier cords

DO NOT suspend strings over product or attach strings to toys.

• DO NOT allow child to spin swing or sleep in exerciser.

- DO NOT allow other children to hang or swing on exerciser.

- ALWAYS remove exerciser from doorway when not in use to prevent entanglement in straps.

- DO NOT alter exerciser or use hardware other than that provided with exerciser.

- NEVER relocate or adjust height of exerciser while child is in seat.

- NEVER give child food or drink while using the exerciser.

Parts List

Seat

Strap (2)

Frame Half (2)

Clamp and Spring Housing Assembly

Ремни закрепляются спереди назад на каждой стороне петли для игрушек располагаются перед ребенком как показано на рисунке

ЗАПРЕЩАЕТСЯ закреплять ремни слева направо так как при этом не удастся достичь правильного положения прыгунков

Внимание: Используйте только игрушки Evenflo вместе с данными прыгунками (в комплект поставки не входят).

Корпус пружины с крепежными захватами

Ремень

Ремень

Петля для игрушек

Петля для игрушек

Передняя часть

Клапан для доступа к трубкам (2 шт.)

Отвороты для крепления ремней

Сборка изделия

1 Возьмите ремень

A Вставьте конец ремня ближайший к петле для игрушек

B в прорезь отворота

C сиденья D.

Внимание: Убедитесь что петля B направлена вверх как показано на рисунке.

2 Проденьте ремень

A через прорезь в задней части отворота C как показано на рисунке.

3 Проденьте другой конец ремня

A в прорезь правого заднего отворота

E затем проденьте через заднюю часть как показано на рисунке

Внимание: Ремень не должен перекручиваться.

4 Повторите шаги 1-3 для закрепления ремня на левом переднем отвороте

F и левом заднем отвороте G.
Нашли ошибку?