Инструкция по эксплуатации Elenberg WM-3620D — страница 15

Removing the shipping bolts

Before using the washing machine you must remove all of the shipping bolts:

1 Take the top cover down.

2 Loosen and take the two bolts down from the fasten stand the polyfoam interleaf under the stand also be taken out.

3 Instal the cover as before 4 Keep the shipping bolts and spring block for future shipment use.

Adjusting the leveling feet

If the floor is uneven losen the leg bolt by turning it with your hand until it is at the desired height Then tighten the locking nut by turning it with the wrench.

Connecting the water supply hose

1 Take the cold water supply hose and connect to the cold water supply intake on the back of the machine Tighten by hand.

2 Connect the other end of the cold water supply hose to water faucet and tighten it The proper faucet should be chosen and its mouth is flat 3 Make sure the connection is good without leaking No excessive bending for the water tub by hands.

Connecting the water drain hose

The drain hose should not be placed 80-100cm high above the floor The strap and retainer should be applied to protect the floor from damage due to water leakage.

UNPACKING AND INSTALLATION