Инструкция по эксплуатации Electrolux EGG6242NOX — страница 8

lets the thermocouple warm up If not the gas supply is interrupted.

3 Adjust the flame after it is regular.

If after some tries the burner does not light check if the crown and its cap are in correct positions.

WARNING!

Do not keep the control knob pushed for more than 15

seconds If the burner does not light after 15 seconds release the control knob turn it into off position and try to light the burner again after minimum 1 minute.

CAUTION!

In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame turn the control knob counterclockwise to maximum gas supply position and push it down Keep the control knob pushed for equal or less than

10 seconds to let the thermocouple warm up.

If the burner accidentally goes out turn the control knob to the off position and try to light the burner again after minimum 1 minute.

The spark generator can start automatically when you switch on the mains after installation or a power cut It is normal.

4.3 Turning the burner off

To put the flame out turn the knob to the off position

WARNING!

Always turn the flame down or switch it off before you remove the pans from the burner.

5 HINTS AND TIPS

WARNING!

Refer to Safety chapters.

5.1 Cookware

CAUTION!

Do not use cast iron pans potstones earthenware grill or toaster plates The stainless steel can become tarnished if it is too much heated.

WARNING!

Do not put the same pan on two burners.

WARNING!

Do not put unstable or damaged pots on the burners to prevent from spill and injury.

CAUTION!

Make sure that the bottoms of pots do not stand above the control knobs otherwise the flame heats the control knobs up.

CAUTION!

Make sure that pot handles are not above the front edge of the cooktop.