Инструкция по эксплуатации Cybex SOLUTION Q2-FIX — страница 12

NOTE! Following these steps will not only ensure that the vehicle’s upholstery is protected but also that the ISOFIX connectors are neither stained nor damaged Damage and stains could obstruct smooth operation.

RELEASING THE ISOFIX CONNECTORS

PUSH!

• Release the ISOFIX connectors (w) on both sides by pushing and pulling back the red release buttons (y).

• Pull the seat out of the ISOFIX guides (u).

• Rotate the ISOFIX connectors 180°.

• Pull the handle (v) located at the bottom of the child car seat and push the ISOFIX connectors (w) as far as possible.

PLACING THE CHILD SEAT IN THE CAR

• Place the child safety seat on the appropriate seat in the car.

• Please ensure that the backrest (a) of the child safety seat rests flat against the backrest of the car seat so that the child seat is under no circumstances in a lying position.

• When using the ISOFIX anchorage points (i) in the car please ensure that the backrest of the CYBEX Solution Q2-fix is perfectly aligned and in full contact with the back of the car seat

The position can be adjusted using the handle (v) located on the bottom of the child seat.

• Should the headrest of the vehicle seat interfere please pull it out completely turn it around or take it off entirely (exceptional case refer to the section “THE BEST POSITION IN THE CAR”)

The backrest (a) optimally adjusts to almost any inclination of the car seat.