Инструкция по эксплуатации Cybex JUNO 2-FIX — страница 13

Warning! The CYBEX JUNO 2-FIX backrest must lie fl ush with the back of the car seat In order to guarantee maximum protection for the child the seat must be in a normal upright position

Carry out the installation steps in reverse order.

NOTE! It is possible that some car seats that are made of soft material (e.g velours leather etc.) may show signs of usage and/or discolouration In order to avoid this you could for example place a cover or towel underneath it In this context we would also like to refer to you to our cleaning instructions which must absolutely be followed before the fi rst use of the seat.

NOTE! Retracting the connectors not only protects the car seat but also protects the ISOFIX CONNECT system from dirt and damage.

PLACING THE CHILD SEAT IN THE CAR

RELEASING THE ISOFIX CONNECTORS

• Release the ISOFIX connectors (w) on both sides by pressing and pulling back the red release buttons (y)

• Pull the seat out of the ISOFIX guides (u)

• Turn the ISOFIX connectors (w) 180°

• Activate the handle (v) on the underside of the child seat and push the connectors in until they reach the end position.

• Place the child seat on the appropriate seat in the car

• To install the seat in an upright position for the child it is essential to take care that the backrest (a) of the child seat lies flush against backrest of the car seat To achieve this push the seat toward the car seat backrest.

• By using the ISOFIX anchorage points (i) in the car you can adjust this distance with the handle (v) on the underside of the child seat.

• If the headrests of the car seats get in the way pull these completely out turn them round or detach them completely (exception see section „THE

BEST POSITION IN THE CAR“) The backrest (a) adjusts itself in one movement to almost every position of the car seat.