Инструкция по эксплуатации Binatone SI-4024 — страница 5

BEFORE USE

Remove all packaging from the appliance.

Turn the steam control knob (9) into the «0»

position and the temperature control knob (10) – into the «Min» position.

If you intend to iron with spray or steam push the cover (4) up and fill the tank (5)

with water through the opening (3) Use the measuring jug (14) for convenience and ease.

Note: If your area has hard water we recommend you use filtered or bottled water.

Attention: Always disconnect the iron from the electricity mains supply prior to filling the tank (5) Do not fill the tank (5) with other liquids.

! Prior to first use iron a clean old piece of cotton cloth to make sure the sole plate and the water tank are absolutely clean (see subsection «Steam ironing» ).

Note: Light smoke may emit during the first use of the appliance: it is a normal occurrence that will soon disappear.

INSTRUCTIONS FOR USE

1 Place the iron into a vertical position.
2 Insert the power plug into the mains supply outlet.

3 Turn the temperature control knob (10) to set the temperature recommended by the manufacturer of the textile article (usually indicated on the article’s label).

Note: In case the manufacturer’s recommendations are missing select the temperature setting which corresponds to the type of the cloth to be ironed (see section «Useful advice» ).

4 The temperature indicator (12) will light up to indicate that the iron is being heated to the set temperature level When the set temperature level is reached the indicator (12) will turn off.

Note: During operation of the appliance the light indicator will light up and turn off periodically; this is normal and not a malfunction.

Steam ironing

Dry ironing can be can be used at any temperature setting To do this the steam control knob (9) must be put into the «0» position If you intend to use the steam function allow the iron to heat to the required temperature level then put the control knob (9)
into the required position.