Инструкция по эксплуатации Binatone CI-110 — страница 4

INSTRUCTION MANUAL

1 Place the appliance on its base (7) upon a dry smooth horizontal surface.

2 Connect the power cord plug to the electric mains and set the switch (5) into “I” position The light indicator (6) will light up showing that the appliance is in operation.

3 Wait for the appliance to heat up to the required temperature (approximately 4-5 minutes).

4 Select a small lock of hair (approximately 15 mm wide) and comb it from roots to tips.

5 Press the lever (4) to open the hair clip (3).
6 Place the ends of the hair between work surface (2) and hair clip (3).

7 Rotate the appliance by the handle (9) to wind the hair onto the work surface For your convenience you may rotate the handle (9) with one hand and support the appliance by the non-heating tip (1) with the other.

8 Treat each lock for around 10 20 seconds.
9 Carefully release the hair by lifting the lever (4) Let the hair cool down.

10.Continue operation as described above to treat all of your hair.

11.Always unplug the appliance immediately after use.

MAINTENANCE

AND CLEANING

1 Clean the irons after every use.
2 Unplug the device and wait until it completely cools down.

3 Use a soft damp cloth to clean the working surface of the appliance (2) and the handle (9) Do not allow water or other liquids to get inside the appliance.

4 If you are not going to use the appliance for some time then let it completely cool down place it in the box and store in a safe dry place out of reach of children.

AFTER-SALES SERVICE

If your appliance does not operate or does not operate properly contact an authorized service center for consultancy or repair.

The warrantee does not cover:

– product packing consumables and accessories (tips etc.);

– mechanical damages and natural wear of the product;
– failures due to overloading improper or careless maintenance penetration of liquids dust insects and other foreign matters inside