Инструкция A.M.E. ММ-1 — страница 9

Инструкция

PDF

1,10 МБ

Автосигнализации

ОлегMaster

Инструкция для A.M.E. ММ-1 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

User’s Guide

AME MM1 Car Alarm System

Installer Software Switches (Just for Reference)

WARNING! Never change the settings of the Installer Functions! If any readjusting is required contact your

installation shop.

*NOTE:

WARNING: The Shock Sensor can be adjusted to operate as either onestage or twostage Sensor. To have

onestage Shock Sensor set the same level of sensitivity for both PreWarn and Main Trigger; for getting

twostage Sensor set the PreWarn Trigger sensitivity at least one level Higher than Main Trigger sensitivity.

1. Once you reach the highest or the lowest sensitivity, no further siren beeps will confirm any further pressings

of the transmitter button.

2. The PreWarn Trigger Sensitivity cannot be set less than the Main Trigger Sensitivity.

3. If you enter the setting, and do not press a transmitter button, the system will exit the setting after 1 minute

automatically and the sensitivity will stay at the previous setting.

**NOTE: If the PreWarn option is set and alarm system is armed with the door open (interior light switched on)

the input will be enabled in 15 seconds after the door is closed (interior light has turned off).

Software Function Default Setting Option 1 Option 2

Switch

1 Dome Light Cars OFF ON OFF

2 Door (+/) Input Polarity Negative Positive Negative

3 CDL Locking Time 0.8s 0.8s 4s

4 Twenty Second Locking OFF ON OFF

5* Shock Sensor Main Trigger Sensitivity 5 Up Down

1 = Minimum Sensitivity (A single beep (A double beep

10 = Maximum Sensitivity will confirm will confirm

LED will flash according to the current setting when each pressing) each pressing)

the switch is selected.

Press buttons 1 and 2 together to enter the setting.

When required sensitivity is set press buttons 1 and 2

once again to confirm and exit the setting.

Shock Sensor will be in a test mode when this

switch is selected to allow testing sensitivity.

6* Shock Sensor PreWarn Trigger Sensitivity 5 Up Down